UBITracer Safety and Compliance Information
Safety Information:
You must follow the device installation guide and ensure that the Hardware Devices always operate within their stated limits of environmental conditions:
No rinse in water: do not immerse or expose the device to water, liquids, or other hazards. Do not clean the product using chemicals or detergents.
No tampering with the device: do not disassemble, modify, damage, destroy, bend, drop, puncture, or incinerate the device or the battery inside the device. Mishandling or damage of the battery may present a risk of fire, chemical burn, electrolyte leak and/or bodily injury.
Charging: charge the device only with 5V, 1.6A charger, otherwise you may destroy the device, result in a risk of fire, or cause injury to persons. Make sure the device is charged with temperature within the range of 41 degrees Fahrenheit to 86 degrees Fahrenheit.
Operating Temperatures: maintain operating temperature from minus 22 degrees Fahrenheit to 140 degrees Fahrenheit. To avoid heat, do not leave the device exposed to fire, a heat source, or high temperatures, such as in the sun in an unattended vehicle. To prevent damage, do not place the device under direct sunlight.
Storage: when storing the device for an extended period of time, make sure the ambient temperature is within the range of 32 degrees Fahrenheit to 77 degrees Fahrenheit, and the storage environment is dry. If the device is not used for a long period, you should charge the device once the remaining battery becomes lower than 30% to avoid battery exhaustion.
Battery disposal: please contact your local waste disposal department to dispose of the device/battery in accordance with applicable local laws and regulations.
UBITracer manufacturers, service providers and distributors (“We”) have the full right to reject any warranty, repair, or refund requests if the device has experienced excessive heat, submerge in water, destructive strike, tampering, dismantling, covered in dust, over discharge of battery, exhaustion of battery, etc. The timely communication of data and provision of services, including the ability to provide real-time monitoring data, may depend on the quality and availability of telecommunication systems. We shall not be held responsible for technical difficulties and data reporting delays resulting from sparse cellular signal, weak cellular signal, temporary cellular service outage and any other detrimental factors. For UBITracer products with satellite positioning, satellite signal may be blocked when not directly exposed to multiple satellites. For UBITracer products with Wi-Fi positioning, Wi-Fi signal may not be available everywhere. Temperature and humidity readings may be inaccurate when newly introduced to a new environment. We shall not be held responsible for inaccurate positioning and inaccurate parameter readings resulting from such adverse operating conditions. Any use of the Hardware Devices beyond the stated purposes, outside the operating environmental conditions, or exposure to any detrimental or hazardous materials and/or conditions constitute abuse of the device. Under any of such circumstances, We shall not be held responsible in any way and by any means.
We cannot guarantee or warrant that YOUR wireless data service will always be available or will always function properly. For this and other reasons, the UBITracer device should not be relied upon for the transmission of data relating to emergency or mission critical situations, and We disclaim any liability for events or damages resulting from such reliance or the failure of the wireless data service to perform or to be available for YOUR use of the UBITracer device.
Declaration of Compliance:
FCC Compliance:
UBITracer devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This product does not contain any user-serviceable parts. Repairs should only be made by an authorized UBITracer service center. Unauthorized repairs or modifications could result in permanent damage to the equipment and void your warranty and your capability to operate this device as per Part 15 of the FCC Rules.
CE Compliance:
UBITracer devices comply with the radio interference requirements of the European Community.
Precautions for Pacemaker and other Medical Device Wearers:
Based on current research, cell phones (and smart devices such as UBITracer devices) do not seem to pose a significant health problem for pacemaker wearers. Nevertheless, people with pacemakers may want to take some simple precautions to be sure that their cell phones (and smart devices) don't cause a problem, including:
Keep the device at the opposite side of the body where the pacemaker is implanted to add some extra distance between the pacemaker and the device. Try to maintain a distance of at least 6 inches (15cm) between the pacemaker and the device.
Avoid placing a turned-on device next to the pacemaker implant. For example, don’t carry the phone in a shirt or jacket pocket directly over the pacemaker.
If you think that interference may be occurring, move the device away immediately.
Contact:
After reviewing this policy, if You have any questions or want more information, please contact Us by e-mail at support@ubitracer.com.
The latest version of this document can be found at www.ubitracer.com/safety.
Effective from March 2023
Last revised: March 2023